A new D2C2 compatible modchip has been released
Non Swap / Direct Boot
Boots Own Region WII Backups Directly
Boots Own Region Gamecube Backups Directly
Boots All NTSC JAP/USA on NTSC WII
Boots NTSC Backups/Originals on PAL WII Partially
Boots PAL Backups/Originals on NTSC WII Partially
Boots Directly Gamecube Original/Backups Imports Partially
Boots All Gamecube Import Backups by SWAP
Great Stability , Stability CAP Built-In
3 Wires + GND + VCC for D2A/DMS/D2B/D2B Cutted
7 Wires + GND + VCC for D2C/D2C2 Boards
D2A/DMS/D2B/D2C/D2C2 Chipset Models Supported
Supports all the WII Versions/Drive currently available
Improved Read Method (No DRE),Audiofix
Multidisc,Multigames,Flash Recovery Mode
Support DVD-R/DVD+R & DVD+RW/DVD-RW/DVD9/DVD+R DL without Booktype
Universal EUROPE/USA/JAPAN Wii Console Supported
Stealth & Anti Error 001 Mode & SSBB DL Support
DVD FIRMWARE UPGRADES,No External Programmer Needed
Upgradeable ACTEL IC by JTAG Programmer
Check out the official site for more info…
http://www.wiizardmod.com
New original WII-CLIP V13 model for Wiizardmod , you can find it on HTTP://www.wii-clip.com,
please take attention of use a GENUINE Wii-clip to avoid any kind of damage on your drive controller IC pins
when using a WII-CLIP clone
Added Advanced Mode + D2E Support !! ----> PICTURE
D2E Upgrade Disc for NOT GOLDEN DOT units --> DOWNLOAD
***This Disc will replace your D2C2 fw for D2E one,DO NOT use it if you've a GOLDEN DOT unit***
Info : Temporary Buy Wiizardmod Shop" temporarily offline because of illegal limitations on our PAYPAL account caused by the legality of this product where it ships from. A new payment system will be installed soon. In the meantime you can send an email and wait for instructions to make direct orders
Reported some D2C2 problematic drives,please use long 5-6cm CK wire over them
Wii save-extractor-ssbb
Creator: SOI
Name: Save Installer
Application: Save Installer 2.0 Waninkoko
Title ID: WASI
Blocks: 19
Tested by: SOI
Click to Download WAD file!
I'm unclear on how this can be useful. How do you install the save on another machine after you extract it? there are no instructions?
まずは sdkey.bin から
DesWaD ver1.0 に IOS21-64-v514.wad.out.wad を読ませて復号すると
IOS21-64-v514.File1.des、IOS21-64-v514.File2.des が出来上がる。
チュートリアルページでは DesWad ver0.1 を推奨しているが、
Filefinder v1.2 が"ウィンドウのフォーカスが無くなると止まる"という
バグなのか仕様なのか世界観なのかわからない問題があるので
分割されていた方がサーチ時間短くて済みます。
Filefinderを起動したら[MD5 HASH]の所に
"EF33E224E45C8D8C35CE32D8A810B603"と入力したら隣のボタンを押して
IOS21-64-v514.File2.desを選んで生成開始。
するとFilefinderのフォルダの中に上のハッシュと同じ名前のフォルダが出来て
その中に key.bin が生成されます。後は sdkey.bin にリネームしましょう。
sdiv.binも同じやり方です。
まずは DesWaD で RVL-WiiSystemmenu-v256.wad.out.wad を復号分割します。
次にFilefinderの[MD5 HASH]に"D9F2B2E045D22D3805A67FE0C340CCD2"を入力して
分割された RVL-WiiSystemmenu-v256.File9.des を選んで生成開始。
5分もするとハッシュ名のフォルダの中に key.bin が出来るので sdiv.bin へリネーム。
Trucha Signer を使用する場合後一つ MD5 blankerってファイルが必要みたいなので
手順はsdiv.binと同じにして Filefinderの[MD5 HASH]に
"4582417D623C81FCA07A46A570C8969E"を入力してfile9を読ませましょう。
ISOの中にRVL-WiiSystemmenu-v256.wad.out.wadでは無く
RVL-WiiSystemmenu-v162.wad.out.wad や RVL-WiiSystemmenu-v190.wad.out.wad だった場合は
復号分割がFile1～9にならないかもしれません。
NOTE: There is a newer version of DesWaD out, but the version I linked to is easier to use for key searching purposes.
* key.bin
Google it! It will have an MD5 of 8D1A2EBCD82A3469B77FACF15D9C8E50
I WILL NOT GIVE OUT KEY.BIN TO ANYONE, NOT EVEN THROUGH PMs!
* UltraEdit, or some form of hex editor
http://www.ultraedit.com/
* An ISO. You may need multiple ISOs...
2. Unzip everything and put them into a central directory.
Note: Some users report that DesWaD.exe will only work in their root directory. I did not run into this.
3. Open up the "wiikeyset.reg" that came with the Trucha Signer in UltraEdit and find the section:
<!--c1-->
"name"="Custom KeySet 1"
"boot1 key"=hex:00,00,00,00,00,00,00,00,00,00,00,00,00,00,00,00
"common key"=hex:00,00,00,00,00,00,00,00,00,00,00,00,00,00,00,00
"sd key"=hex:00,00,00,00,00,00,00,00,00,00,00,00,00,00,00,00
"sd iv"=hex:00,00,00,00,00,00,00,00,00,00,00,00,00,00,00,00
"md5 blanker"=hex:00,00,00,00,00,00,00,00,00,00,00,00,00,00,00,00<!--c2-->
<!--ec2-->
4. Open the key.bin file in UltraEdit and make sure you are in hex mode (Ctrl-H).
5. Replace the "common key" line...
<!--c1-->
<!--ec2-->
...with the contents from key.bin. For example, if key.bin contained AABBCCDDEEFFAABBCCDDEEFF11223344, you'd enter...
<!--c1-->
<!--ec2-->
6. Save the "wiikeyset.reg" file and activate it by double clicking on it. Click "Yes" to add it to the registry.
Savegame Extractorで吸い出したセーブデータの中にあるBANNER.BINのアドレス07の値を01から00へバイナリエディタで書き換える
Gecko 1.9.1 - now with channel hacking/cheating!
Gecko 1.9.1 - now with channel hacking/cheating!
Gecko 1.9.1
What's New: